The Fluke 80i-2010s AC/DC Current Clamps are used to measure up to 2,000A AC and/or DC on large conductors with 0.8% accuracy.
The Fluke 80i-2010s AC/DC Current Clamps are used to measure up to 2,000A AC and/or DC on large conductors with 0.8% accuracy.
| Manufacturer part number (MPN) | 5125579 |
| Brand | Fluke |
| Category | Tools |
| Modules | 80i-2010s |
| Dimensions | 110 mm x 270 mm x 46mm |
| Weight | 0.710 kg (1.6 lbs), including battery |
| Output Cable | 1.5 m (60 in) Shielded Coaxial cable with BNC plug |
| Maximum Conductor Size | 52.0 mm (2.05 in) |
| Maximum Jaw Opening | 81.5 mm |
| Output to Zero | Auto adjustment with Zero button |
| Temperature Operating | -10 °C to 50 °C (14 °F to 122 °F) |
| Storage (battery removed) | -30 °C to +60 °C (-22 °F to +140 °F) |
| Operating Humidity | ≤ 90 % RH (at 10 °C to 30 °C) ≤ 75 % RH (at 30 °C to 40 °C) ≤ 45 % RH (at 40 °C to 50 °C) |
| Operating Altitude | 2,000 m (6560 ft) |
| Storage Altitude | 12,000 m (40,000 ft) |
| Demagnetize Clamp | Open and close the Clamp jaws several times with soft click, use of the clamp on uninsulated conductors is limited to 1000 Vac rms or DC and frequencies 1 kHz or less. |
| Safety | IEC 61010-1, Pollution Degree 2 |
| IEC 61010-2-032 | CAT III 1000 V /CAT IV 600 V |
| Ingress Protection | IEC 60529, IP40 |
| Power Supply Type | 2 x AA alkaline battery, IEC LR6 |
| Battery Life | 150 hours (typically) |
| Low battery indicator | Yes |
| Current Range | 2000 A ac rms, ± 2000 A dc |
| Output Sensitivity | 01 mV/A |
| Accuracy | ± 0.8 % of reading ± 0.2 % of range |
| Bandwidth for Accuracy Specification | DC to 400 Hz |
| Load impedance | >1 MΩ and <10 pF |
| Frequency Response (small signal) | DC to 20 kHz (-3 dB) |
| Temperature Coefficient | 0.1 x specified accuracy for each degree C above 28 °C or below 18 °C |
| Working Voltage | 1000 V AC RMS or DC |
| MOQ | 1 |