| Type | 2/2-way direct-acting plunger |
| NC |
| Body | brass G 1/8 to G 1/2 |
| Orifice | 1.2-6 mm |
| Pressure | 0-15 bar (depends on orifice) |
| Coil | 24 V DC / 230 V AC |
| Temperature | -10 to +90 °C. |
| Seal | FKM, EPDM, NBR, PTFE and PEEK |
| Body | Brass, stainless steel 1.4404/316L |
| Coil | Epoxy |
| Orifice | DN 1.0...DN 13.0 |
| Thermal insulation class of | Epoxy coil class H |
| Duty cycle | 100 % continuous operation |
| Switching time AC | Opening: 10...30 ms Closing: 50...80 ms |
| Switching time DC | Opening: 20...30 ms Closing: 50...80 ms |
| Operating voltage | 24 V DC, 24 V 50 Hz, 24 V 60 Hz, 110 V 50 Hz, 120 V 60 Hz, 230 V 50 Hz, 240 V 60 Hz, others on request |
| Voltage tolerance | ± 10 % |
| Standard | Vacuum, neutral gases and liquids (e.g. compressed air, water, hydraulic oil, petrol, DVGW 1 - 3 gas family) and slightly aggressive medium, hot liquids and steam |
| Oil burner variant (PF15) | Heating oil (EL, L, M, S) acc. to DIN 51603 part 1...6, shipping fuels acc. to ISO 8217 Only with stainless steel body: Fatty acid methyl ester (FAME) acc. to DIN EN 14213,... |
| Medium temperature | Seat seal/external seal |
| Standard variant | FKM/FKM: - 10 °C...+ 140 °C EPDM/EPDM: - 30 °C...+ 120 °C NBR/NBR: - 10 °C...+ 80 °C PTFE/FKM: - 10 °C...+ 140 °C PTFE/PEEK: - 40 °C..+ 180 °C |
| High pressure variant up to | PEEK/FKM: - 10 °C...+ 80 °C |
| Approval DIN EN 161 (PO19) | NBR/NBR: - 20 °C...+ 80 °C FKM/FKM: 0 °C...+ 125 °C |
| Viscosity | Max. 21 mm2/sec 1.6...76 cSt (DN 2, 2 NC 1.6...22 cSt) (Oil burner variant PF15) |
| Port connection | G ¼, G ⅜, G ½, G ¾, NPT ¼, NPT ⅜, NPT ½, NPT ¾ (RC on request) |
| DIN CERTCO registration | DN 2,2 (NO) Reg |
| No. | 5 sec. 255 |
| Degree of protection | IP65 with cable plug Type 2518 NEMA 4X with cable plug Type 2509 with stainless steel variants |
| Installation position | As required, preferably with actuator upright |
| Ambient temperature | Max. + 55 °C Max. + 70 °C with Kick and Drop coil 4.) - 15 °C...+ 60 °C (Oil burner variant PF15) |
